Product introduction

I-Beam Festoon System is used in hanging and moving for mobile power supply mechanical cable. It has been widely used in all kinds of hoisting machinery. The device is of firm structure, flexible movement, safety and reliability. Light load type cable conduction is made up by three parts including towing trolley, middle trolley and end trolley. The towing trolley follows a moving mechanical traction sheave guide rope traction device, each of which configures 1 towing trolley to run back and forth with the mobile machinery. Middle trolleys follow the towing trolley with the cable hanging within the scope of I-beam rail traction, and the slow clashes is equipped on both ends of them. The number of trolleys depends on different length of mobile. End trolley is fixed at the end of I-beam rail, general each mobile machinery set 1.

Install Caution

1, Fixed line installed, should be hung behind a baffle.

2, Adjust the drawing head, make the car in the whole trip without touching traction hole top and bottom edge as well.

3, Cable length for crane span 1.2 instead of 8 meters.

4, Adjust the traction rope, make its length is less than the section with cable length, runtime by load cable force.

5, When the cable diameter range, should pad between cable clamp with soft rubber, make its have the same diameter, so that the cable clamp.

6, Cloth cable, both sides should consider cable plate stress equilibrium.

7, When the cable pulley is on the second floor for the same.

8, The double gasket on the block device for adjusting washers, when the guide rail is improper, put the washer on the inside of the fixed plate, in order to adjust the track width, the factory according to the guide for 100 * 68 120 70 140 * 80 * 70 * 140.Non-standard block processing system according to the drawing.

Technical Feature

NANTE:

After 20 years rapid development, NANTE and its parents company ZHONGJIAN Group has grown into a leading integrated solution provider for crane and crane components in China.  Dedicated to the research and development of new lifting and handling technologies, we adopt innovative ideas and design in developing new products and services. Backed up by a wealth of industrial experience on lifting industry, WE can provide to customer wide range of lifting equipment and components with scientific design, good safety, high performance, efficient operation and low maintenance cost.  We are committed to help our clients to reduce investment cost, improve production efficiency, and economize energy consumption.

OUR PRODUCTS:

In order to offer our clients with a complete set of competitive lifting solution. WE delivers a wide range of products include:

1. Lifting Equipments for Construction: Beam Launcher, Gantry Crane, Segment Lifter, Form Traveler, and Bailey Bridge etc.

2. Lifting Equipments for Industry: Overhead Crane, Gantry Crane, Jib Crane, Light Crane System.

3. Crane Components: Electric Hoist & Trolley, End carriage, Conductor Rail, Festoon system, Steel Rail, Flat cable, Pendent control, geared motor, remote control etc.

Our Service

WE can provide to customer an integrated solution which includes project consultant, design, manufacturing, transportation, installation, maintenance and technical support. Our one-stop services can not only save our customers time but also minimize their cost.

In compliance with our service concept “Customer First”, we provide the following support services to ensure smooth running of customer’s lifting and handling equipments: Presale Technical Support, After-sale Maintenance, Spare Parts Support, and Customized Solutions.